Welcome Guest!!!

Thank you for visiting the GM Kappa Performance Forum. This forum is the only performance oriented forum for all GM Kappa Platform Enthusiasts.  We hope you will join and share your experiences.  Becoming a member is FREE! If you want to advertise on this forum, email KappaPerformance at yahoo.com.


Registration required to view the forum attachments. Below is a sample of the current top 25 topics.
Supporting Membership has many advantages.


More information on becoming a supporting member or vendor can be found on the sub forum; Site Help and Suggestions; thread - Supporting Members and Vendors.

Author Topic: Went for a spin this morning .....  (Read 8963 times)

0 Members and 1 Guest are viewing this topic.

Offline Gentleman Jack

  • Chief Financial Officer, Color Professional
  • Premium Member
  • Shop Foreman
  • *
  • Posts: 8982
  • Karma: +26/-82
  • Location: Unknown
  • I'm here. If I wasn't here, I'd be there.
Re: Went for a spin this morning .....
« Reply #25 on: February 15, 2010, 01:03:35 AM »
as with all the others, glad that you are doing well.  6K, wow.  Cars are pricey fixes these days.  Perhaps you could have tigger shipped to MMM7 and we would just do all the work there?  :)

GJ
Make the right choices now

Offline Lithium Lotus

  • Master Tech
  • ***
  • Posts: 132
  • Karma: +0/-0
Re: Went for a spin this morning .....
« Reply #26 on: February 15, 2010, 02:55:02 AM »
at least you didn't get hurt too bad
07 GXP: Natsumi "Summer Beauty"
Sold 08/2010

Offline Derf

  • Tech
  • **
  • Posts: 45
  • Karma: +0/-0
  • Location: Fort Worth TX
Re: Went for a spin this morning .....
« Reply #27 on: February 15, 2010, 07:28:03 PM »
Read this today  :gaah: glad you are ok.

Offline duckSol

  • Founding Member
  • Master Tech
  • *
  • Posts: 662
  • Karma: +0/-0
  • Location: IRDC
  • Onward through the fog
Re: Went for a spin this morning .....
« Reply #28 on: February 15, 2010, 09:53:06 PM »
Glad you are ok.
Have someone who knows you watch you closely over the next week. You have had closed head trauma (been there) and it may not kick in right away and lets hope it don't. The effects can be real subtle, so please be careful, even insist on a CAT scan without and with contrast dye.

On a side note, I found out today the State of NC has lost their record of my Federal waiver for my CDL even though I have renewed three times under the waiver. This has been going on since last Thursday.
I would like to think the CD's were glad you were ok. Changing lanes is very dangerous approaching an MVI and cannot happen all the time for every vehicle regardless of GVW.
2012 Summer SOLSTICE In The Land Of SKY

Offline Critterman

  • Retired, thank you very much
  • Premium Member
  • General Manager
  • *
  • Posts: 13699
  • Karma: +18/-58
  • Baltimore/Washington Corridor
Re: Went for a spin this morning .....
« Reply #29 on: February 15, 2010, 11:02:20 PM »
going to be a translator for truck driving duck.

CDL = comercial drivers license
CD = commercial drivers
NVI = motor vehicle incident
GVW = gross vehicle weight
GONE: (but not forgotten) 2006 Cool named IXABEL (BISH-AH-BEL) Mayan for "Good Roads"
DDM StageIII intercooled Supercharger, Wisco ceramic coated pistons, Carrillo rods, superTech valves and Springs, Ported and polished head, Exedy Stage II Clutch,
big brake kit, slotted/drilled Rotors w/Porterfield pads & blue juice, Backbone, Probeam, Cross Strut Brace Underhood, trunk, & door Lights, ZOK suspension
JPM Center console, door inserts, & dash Seat bolster & lumbar support
Focuztech Tri-Y Header & hi-flow cat, Solo Performance SQR-2, Norm's Rear facia, Heated Seats, Blackface gau

Offline DRGNSLR

  • Premium Member
  • Tech
  • *
  • Posts: 59
  • Karma: +0/-0
  • Location: Crimson Tide Land
Re: Went for a spin this morning .....
« Reply #30 on: February 17, 2010, 01:30:16 AM »
 :ttiwwpic2:

Before & after repair pics preferred.
Gordo

“Dragon Slayer”
Yellow '08 RL, manual tranny
Options: shiny rims, mud flaps, aerodynamically questionable airfoil
Mods: GMPP LNF tune, DDM Backbone & Pro-Beam, etched glass Windblade, JPM seatbelt loops & knee pad
Upgrades: Phase-plasma rifle in the 40-watt range
[A/K/A Gordo SH-3]

 

Powered by EzPortal